Panasonic S-36PU1E5A Technical Data & Service Manual page 288

1
Connecting 2 remote controllers
to control 1 indoor unit
Remote controller
(main)
Optional
1 2
1 2
Indoor unit
U1 U2
Ground
1 2
Outdoor unit
Ground
Remote controller setting mode
To set the remote controller main/sub setting or change the sensor, follow the steps below.
(1) Press both
(2) Select CODE No. with
(3) Change DATA with
(4) Press . Finally, press
* DATA is memorized in the RCU. (DATA setting will not be changed even when the power is turned off.)
* Make sure to set [Normal] for RCU. CK.
CODE
ITEM
Remote controller
(sub)
Optional
1 2
Remote control wiring
Terminal board for
remote control wiring
and buttons on the remote controller for more than 4 seconds together.
/ (
/ (TIMER) buttons.
.
ITEM
RCU. Main/Sub
Clock display
RCU. CK
Room temperature sensor
Connecting 2 remote controllers to control a
simultaneous-operation multi system
Remote controller
Remote controller
(main)
(sub)
Optional
1 2
Terminal board for
remote control
wiring
1 2
Indoor unit 1
U1 U2
Ground
1 2
Outdoor unit
Ground
) buttons.
DATA
Sub
24 hours 12 hours (AM/PM)
RCU. CK Normal
Main unit
1-278
Remote control
Optional
communication
1 2
wiring
Terminal board for
remote control
wiring
1 2
Indoor unit 2
U1 U2
Ground
Inter-unit
control wiring
Main
RCU