Panasonic S-36PU1E5A Technical Data & Service Manual page 641

3. Wiring the Receiver
Wiring Diagram
Connections
Connect the wires from the receiver to the remote control terminal strip on the indoor unit. (Polarity does not matter)
4. Test Operation
Implementing a Test Run
1. Turn the #1 DIP switch [S003] on the receiver's PCB
from OFF to ON and operate the wireless remote
control with its Start/Stop button.
2. During a test run, all display lamps on the display will
light up.
3. During a test run, it is not possible to adjust the
temperature.
4. After completing a test run, be absolutely sure to turn
the #1 DIP switch from ON to OFF and make sure none
of the display lamps are blinking. Also, replace the PCB
cover back as it was and fasten it; while holding the
wiring with the cable clamp, tighten its screw.
NOTE
(1) This is hard on the device, so only use this for the test
run.
(2) After turning on the power, the unit will not receive any
commands from the remote control for about 1 minute.
This is not an error. (In fact it does receive signals, but
they are cancelled.)
5. Setting Address Switches
When more than one receiver and remote control are installed in the same room, setting up addresses allows them to avoid
interfering with each other.
Refer to the Users Manual for information on how to change the addresses of the remote controls.
Changing the address of a receiver can be done after removing the screw to the receiver's PCB cover. Once the change is
complete, put the cover back in place; while holding the wiring with the cable clamp, tighten its screw.
Address Display
on the Remote
Control
Position of the It doesn't matter
Receiver's where the receiver's
Address Switch address switch is.
Indoor Unit
Terminal Strip for
Wiring Remote
Controls
Receiver PCB
White
Black
CZ-RWSU2
Screw
Cable
clamp
PCB cover
8-17
S003
Bit 1: OFF → ON
ON
Receiver
PCB
Adjustable
Corner Cap
Fig. 8-5
8