Final Installation; Installation Of Air Defl Ection Glass; Glass Only Placement; Glass & Optional Stone Kit Placement - Vermont Castings AVFL42NTSC Installation & Operating Instructions Manual

FINAL INSTALLATION

INSTALLATION OF AIR DEFLECTION
GLASS
NOTE: The 32" defl ector glass must be installed prior
to placing any fi reglass or stone media on the burner.
To install the air defl ection glass simply place the tabs
located at the bottom of the glass into the slots at either
end of the burner fl oor, in front of the burner ports. The
glass should stand upright, neither leaning forward nor
backward.

GLASS ONLY PLACEMENT

NOTE: Two (2) bags of glass are supplied with the fi replace.
Both bags may be used to cover the entire fl oor and burner.
We advise against using additional glass as too much can
cut off the proper amount of air the burner needs to burn
cleanly. This may cause sooting.
Air Defl ection Glass Placement (before)
Examples of
Stone Placement
Figure 10A –
Air Defl ection Glass and Stone Placement
20305467
1. Spread glass evenly in one layer over the entire fl oor
2. Turn burner on and adjust glass over ported areas to
GLASS AND OPTIONAL STONE KIT PLACEMENT
1. For best results, spread glass evenly over the entire
2. Place the stones randomly in front of and behind the
3. Turn burner on and adjust glass over the ported area
Burner Surface
and burner. It is important to not have the glass too thick
on ported area (single layer only).
achieve an even, clean fl ame.
fl oor and burner making sure the glass is not too thick
over the burner ports (single layer only). Figure 10A.
burner. CAUTION: Do not allow stones to sit directly
on burner or in fl ame. Figure 10A and 10B.
to achieve an even, clean fl ame. Page 28, Figure 29
Air Defl ection Glass Placement (after)
Rear Vent
AVFL Vent Free Fireplace
15