Cuber Sanitizing And Cleaning Procedure - Cornelius ICE MAKER Pocket Manual

Add 1/2 oz. "sanitizer" to a gallon of lukewarm wa-
ter. With a non–metallic bristle brush, scrub the inte-
rior of the ice bin including the under side of the
door, and the outside of the ice chute that protrudes
into the ice bin.
7. Rinse interior bin with clean water. (NOTE: Steps 6
and 7 should take no less than 10 minutes).
8. Not less than 10 minutes after completing step #4,
turn switch to "OFF" and repeat step #2. After the
evaporator and float chamber have drained, restore
hose to float chamber, release float, replace float
cover and turn water on if necessary.
9. Turn switch to "ON". Collect and throw away the
first gallon of ice.
NOTE: APPROVED SANITIZER: "Calgon Ice
Machine Sanitizer" or Household Bleach.
CUBER SANITIZING AND CLEANING PRO-
CEDURE
1. Remove front panel to gain access to the on–off–
clean switch.
2. Push switch to "clean" and allow the ice on the
evaporator to release of melt away.
3. Remove ice from storage bin.
4. If lime scale is present add 2 oz. of "Lime-A-Way" or
"Calgon Nickelsafe Ice Machine Cleaner" directly
into water reservoir. Circulate for no longer than 15
minutes. Depress dump valve switch on control
box and allow cleaner or sanitizer to drain away.
Allow float valve to fill reservoir with clean, fresh
water. Circulate for approximately 1 minute. De-
press dump valve switch and allow water to drain
away. Repeat three times.
CAUTION: All ice machine cleaner must be flushed out of
the system before the sanitizing solution is used in Step 5.
The reaction of the two chemicals can cause hazardous gases
to be generated.
5. Pour 1/2 oz. of household bleach into the water res-
ervoir and circulate for 15 minutes to sanitize the
15 TD 184