Cleaning Procedures; Cleaning Procedure If There Is Ice On The Evaporator Plate - Cornelius XAC 1444 Service Training Manual

Xtreme ice xac series; xwc series; xrc series;

Hide thumbs Also See for XAC 1444:

Specifications (20 pages)

Table Of Contents

Table of Contents

Approved ice machine cleaners by brand names:

S Calgon Nickel Safe (green color only)

NOTE: Failure to use approved products will void the warranty.

CAUTION: Ice machine cleaners are acidic-based chemicals. Before beginning any

cleaning of the cuber, the ice in the storage bin or dispenser must be removed.

WARNING: When using any chemical, rubber gloves and eye protection should be worn.

Cleaning Procedure if there is ice on the evaporator plate.

1. Turn the power switch on.

2. Press and hold the Harvest button to start a 4 minute defrost cycle. (Button is located on the control

board see Figure 5).

HARVEST

UNIT

SELECTION

SWITCH

S3–2

RH EVAP

SWITCH

BIN

LH EVAP

SWITCHES

SWITCH

STOCKING

CABLE PLUG

NOTE: CONDENSER SENSOR USED ONLY ON A/C UNITS.

1.8K ohm RESISTER USED ONLY ON W/C AND R/C UNITS.

FIGURE 5

NOTE: Condenser sensor used only on A/C units. 1.8k resistor used only in W/C and R/C units.

Single evaporator units must have the proximity connected in the top connection.

TP00952