Campbell Hausfeld AL2710 Operating Instructions And Parts Manual page 3

Operating Instructions and Parts Manual
Airless Paint Systems
General Safety
Information
(Cont.)
4. Do not smoke or eat when spraying
paint, insecticides, or other
flammable substances.
5. Always work in a clean
environment. To avoid injury and
damage to the workpiece, do not
aim the spray gun at any dust or
debris.
6. When spraying and cleaning,
always follow the instructions and
safety precautions provided by the
material manufacturer (Refer to
MSDS).
DANGER
!
ELECTrICAL SHOCk HAzArD:
● Follow all local electrical and safety
codes, as well as the National
Electrical Code (NEC) and in the
United States, the Occupational
Safety and Health Act (OSHA).
● This product requires a grounded
120V, 15 Amp circuit (See Figure 1).
● If the power receptacles available
RESET
TEST
Grounded Outlet
Grounding Pin
Figure 1 - Grounding
will not fit this equipment's power
cord, then have an appropriate
power receptacle installed by a
certified electrician.
● Only qualified electricians or
service personnel should perform
maintenance on the electrical
components of this equipment.
● If using an extension cord, use only
grounded three wire extension
cords that are in good condition. See
Table 1 on page 4 for information
on proper extension cord gauges.
● Do not modify any of the electrical
components of this
equipment.
● Do not use a power cord
adapter with this
equipment.
● Check with a qualified electrician or
service person if the grounding
instructions are not completely
understood or you are in doubt as
to whether the equipment is
properly grounded.
!
SkIN INjECTION HAzArD:
● High pressure spray can inject
toxins into blood
stream. If injection
occurs, seek
emergency medical
treatment.
WARNING
!
face mask/respirator and
protective clothing when
spraying. Always spray in a
Grounded
well ventilated area to prevent health
Outlet
and fire hazards. Refer to Material
Safety Data Sheets (MSDS) of spray
material for details.
● Never try to stop leaks with any
part of your body.
Box
● This system is capable of producing
3000 psi. Use only Campbell
Hausfeld replacement parts rated
at 3000 psi or higher.
● Never spray without tip guard.
● Ensure trigger lock is functioning
properly.
● Always engage trigger lock when
not spraying.
● Do not remove spray tip while
cleaning pump.
● Never leave equipment pressurized
while unattended.
WARNING
use a
3
PrESSUrE rELIEF PrOCEDUrE
Before servicing or resting unit,
relieve pressure from system by
following this procedure:
1. Engage gun trigger lock.
2. Turn unit off and disconnect
power.
3. Disengage gun trigger lock.
4. Trigger gun
into
grounded
pail to relieve
pressure in
hose and
gun. While doing so, hold metal
part of gun in contact with pail.
Use the smallest amount of
pressure possible.
5. Turn Prime/
Pressure Relief
Valve (PR
Valve) to the
Wide Gap
open (priming)
position to
relieve
pressure.
Slight Gap
NOTE: There
will be a wider gap between valve
handle and cam body when in
open position.
6. Engage gun trigger lock. Close
Prime/Pressure Relief Valve.
NOTE: If spray tip or hose is clogged,
follow step 1 to 5. If you suspect
pressure has not been relieved after
following this procedure, take your
unit to a Campbell Hausfeld Service
Center.
● Do not clean spray tip while it is
attached to the spray gun. Remove
spray tip from gun to clean tip
guard.
● Ensure tightness of high pressure
connections.
www.chpower.com
AL2710