Table of Contents
Advertisement
figure 4A
1.
Insert the Needles (5A) through the holes in the Needle Holder (4A). There are
nineteen Needles. Make sure all holes are filled before putting the Needle Holder
(4A) through the Spring (3A), the Retainer Clip (2A) and into the Barrel Assembly
(1A). Slide one Retainer Ring (8A) around the Needles (5A) and fasten it at the front
end of the Barrel Assembly (1A). See figures 4 & 4A
2.
Holding the Barrel Assembly (1A) in one hand with the Needles (5A) pointing down-
ward, insert the Needle Driver (6A), the Screw Cap (7A) and the last Retainer Ring
(8A). See figures 4 & 5
3.
The Screw Cap (7A) has a Set Screw that holds it in place. Be very careful NOT
to tighten the Set Screw too tightly, snug is good. Otherwise you may damage the
plastic threads inside the Screw Cap (7A) causing it to bind or strip some threads.
4.
Insert the Barrel Assembly (1A) into the end of the Air Hammer Housing (1) and
thread the two parts together. As before do not over tighten, snug is good.
5.
The Air Hammer is now ready to be used as a Scaler.
for technical questions, please call 1-800-444-3353.
SKU 95801
Hex Wrench for Set Screw (included)
Hole for Set Screw
8A 7A 6A
1A
figure 5
2A
5A
Page 8
Advertisement
Table of Contents
