Xerox Phaser 6100 Service Manual page 88

Disassembly
8. Disconnect 8 harnesses from the DEVE drive board: CN1, CN10, CN5, CN9, CN4, CN8, and supply.
9. Remove 6 screws (3*10 silver) and then take out the DEVE drive Board
Caution
CN5, CN9, CN4, and CN8 are keyed the same and can be plugged in incorrectly. Start with CN8
which corresponds to the bottom clutch assembly, then work up to CN4, CN9, and CN5..
Screw
Screw
Screw
Screw
10. Remove the 4 high-voltage terminals to ensure they don't become damaged or lost.
Caution
Do not lose or damage the terminal springs.
.
6-32
Screw
Screw
Terminal
Terminal
Terminal
Terminal
BLCD_DEV
CN1
SOL_T1_CLN
CN10
SOL_1ST
CN6
SOL_4TH CN3
CLT_4TH CN5
CLT_3RD CN9
CLT-2ND
CN4
SUPPLY
CN7 SOL-3RD
SOL-2ND
CN2
CN1
CLT-1ST
CN8