Operation Manual - Sharp CD-DVD500 Service Manual

CD-DVD500
Setting the Clock
In this example, the clock is set for the 12-hour (AM 12:00) display.
1
Press the POWER button to turn the power on.
2
Press the CLOCK button and within 5 seconds, press the
MEMORY/SET button.
3
Press the TUNING/TIME (
24-hour display and then press the MEMORY/SET button.
"AM 12:00"→ The12-hour display will appear. (AM 12:00 - PM 11:59)
"AM 0:00" → The12-hour display will appear. (AM 0:00 - PM 11:59)
→ The 24-hour display will appear. (0:00 - 23:59)
"0:00"
Note that this can only be set when the unit is first installed or it has been reset.
Remote Control
Test of the remote control
Face the remote control directly to the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the POWER button. Does the power turn on? Now, you can enjoy your system.

OPERATION MANUAL

or ) button to select the 12-hour or
Remote sensor
0.2 m - 6 m
(8" - 20')
4
Press the TUNING/TIME (
then press the MEMORY/SET button.
Press the TUNING/TIME (
hour
When the 12-hour display is selected, "AM" will change automatically to "PM".
5
Press the TUNING/TIME (
and then press the MEMORY/SET button.
Press the TUNING/TIME (
minute. Hold it down to change the time in 5-minute intervals.
The hour will not advance even if minutes advance from "59" to "00".
The clock begins counting from "0" seconds. (Seconds are not displayed.)
The time display will disappear after a few seconds.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The "CLOCK" or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning.
If the time display is flashing, step 3 (for selecting the 12-hour or 24-hour display) will
be skipped.
To change the 12-hour or 24-hour display:
1. Clear all the programmed contents.
[Refer to "Clearing all the memory (reset)".]
2. Perform "Setting the Clock" from the beginning.
Clearing all the memory (reset)
1
. Press the POWER button to enter the power stand-by mode.
2
.Whilst pressing down the
POWER button until "CLEAR AL" appears.
Caution:
This operation will erase all data stored in m emory including clock, timer settings,
tuner preset.
Before transporting the unit
1.
Press the POWER button to turn the power on.
2.
Press the DVD/CD button.
3.
Press the OPEN/CLOSE button to open the disc tray.
Remove all discs from the unit.
4.
Press the OPEN/CLOSE button to close the disc tray.
Make sure that "NO DISC" is displayed.
5.
Press the POWER button to enter the stand-by mode, "GOOD-BYE" is dis-
played.
6.
When "GOOD-BYE" disappears, unplug the AC power lead from the AC
socket.
7.
Insert the transport screw into the back of the unit and tighten it with a flat-
blade screwdriver.
– 6 –
or ) button to adjust the hour and
or ) button once to advance the time by 1
or ) button to adjust the minutes
or ) button once to advance the time by 1
button and X-BASS/DEMO button, press the