Wall Mounting - Uniden UCIS-3050C Owner's Manual

Enter the area code(s) for numbers that you dial using ten digits
(e.g., 514-555-1234). You can store up to three area codes for
ten-digit dialing. Press Dial/Enter when you are done. If there
is no number you dial using ten digits, then press Dial/Enter.
Press the Menu or
7.
Save button to save
these operating set-
tings and to exit the
menu mode.
8. After installation, lift
the telephone's Handset and listen for the dial tone. If there is
no dial tone, check to make sure all cords are firmly plugged
into their jacks.
Note: Programming your area code
will allow you to easily dial numbers
REMARQUE
that are in your Caller ID list. See
the Section "Calling Back a Num-
ber from the Caller ID List" for
more information on dialing calls
from your Caller ID list.

Wall Mounting

1. Turn the phone over so that you are look-
ing at the bottom of the phone. Insert
tabs at the thin end of the wall mount
bracket into the holes at the rear of the
phone bottom. Press and latch the tabs
at the thicker end of the wall bracket into
holes at the front end of phone. The back
of the phone should then have two round
plastic holes that can be used to hang your
phone on the wall.
2. Use the two round holes to hang the phone on the wall plate
on your wall.
Important Note: If you do not wish to mount your phone
on the wall, the Wall Mount Bracket can be reversed to
REMARQUE raise the angle of the phone's display when sitting on a
table or desk.
7