Suzuki DF200 Service Manual page 37

(3) Screw new filter on by hand until filter O-ring contacts the
mounting surface.
(4) Tighten filter 3/4 turn from point of contact with mounting
surface using an oil filter wrench.
" Engine oil filter: 14 N·m (1.4 kg-m, 10.0 lb-ft), 3/4 turn
6. Install new gasket and oil drain plug.
Tighten engine oil drain plug to specified torque.
" Engine oil drain plug: 13 N·m (1.3 kg-m, 9.5 lb-ft)
#
Do not re-use gasket once removed. Always use a new
gasket.
7. Pour recommended engine oil into oil filler opening, then
install oil filler cap.
Engine oil amounts
Oil change only: 8.0 L (8.5/7.0 US/Imp. qt)
Oil filter change: 8.2 L (8.7/7.2 US/Imp. qt)
8. To reset oil change reminder system's operation time to zero
(cancellation);
(1) Turn ignition key to "ON" position.
(2) Pull out emergency stop switch plate 1.
(3) Pull up emergency stop switch knob 2 three times in ten
seconds. A short beep will be heard if cancellation is suc-
cessfully finished.
(4) Turn ignition key to "OFF" position, then set emergency
stop switch plate 1 in original position.
NOTE:
See "OIL CHANGE REMINDER SYSTEM" section on page
3-45.
9. Start engine and allow it to run for several minutes at idle
speed.
Check oil filter for oil leakage.
Turn off engine and wait for approx. two minutes, then
recheck engine oil level.
PERIODIC MAINTENANCE
Full level
line
Low level
line
2-5