Suzuki DF200 Service Manual page 119

3-58 ENGINE CONTROL SYSTEM
CMP SENSOR SIGNAL
" 09930-89340: 26-pin & 34-pin test cord
09930-99320: Digital tester
$ Tester range: % DCV (See chart for range.)
1. Turn ignition switch OFF.
2. Remove CMP sensor. (See page 3-69.)
3. Connect the 26-pin & 34-pin test cord between ECM and
wire harness as shown in figure.
4. Connect the tester probe ("+", Red) to each terminal.
CMP sensor
No. 1
No. 2 (VVT_PORT)
No. 3 (VVT_STBD)
5. Connect the tester probe ("-", Black) to No. 49 terminal (or
to body ground).
6. Turn ignition switch ON.
7. Measure the voltage when the tip of a steel screwdriver is
brought near and then pulled away from the sensor tip.
When screwdriver is brought near: Approx. 5 V
When screwdriver is pulled away: Approx. 0.3 V
If the voltage does not change in the above test, replace the
sensor.
Wire color
Terminal
(engine harness)
5 Y/Bl
7 O/G
6 B/O
(White connector)
27 28 29 30 31 32 33 34 35 36 37 38 39 44 45 46 47 48 49 50 51 52 53 54 55 56
40 41 42 43 57 58 59 60
(Black connector)
1 2 3 4 5 6 7 8 9 10 11 12 13
(White connector)
Wire harness
26 pin test cord
5 6 7
(White connector)
34 pin test cord
49
(Black connector)
1
1. Screw driver
2. CMP sensor
ECM
(Black connector)
14 15 16 17 18 19 20 21 22 23 24 25 26
2