Maintenance And Upgrades; Testing The Network Connection; Unit Reset - Bosch VideoJet X10 Installation And Operation Manual

VideoJet X10
7

Maintenance and Upgrades

7.1

Testing the Network Connection

You can use the ping command to check the connection between two IP addresses. This
allows you to test whether a unit in the network is active.
1.
2.
If the unit is found, the response appears as Reply from ... followed by the number of bytes
sent and the transmission time in milliseconds. If not, the unit cannot be accessed over the
network. This might be because:
–
–
7.2

Unit Reset

You can use the Factory Reset button to restore the unit to its original settings. Any changes
to the settings are overwritten by the factory defaults. A reset may be necessary, for example,
if the unit has invalid settings that prevent it from functioning as desired.
CAUTION!
! All configured settings will be discarded during a reset.
If necessary, back up the current configuration using the Download button on the
Maintenance configuration page (see Abschnitt 5.35 Maintenance, Seite 91).
NOTICE!
i
After a reset, the unit can only be addressed via the factory default IP address. The IP address
can be changed as described in the Installation chapter (see Abschnitt 4.5 Setup Using the
Configuration Manager, Seite 25).
1.
2.
3.
4.
Bosch Security Systems
Open the DOS command prompt.
Type ping followed by the IP address of the unit.
The unit is not properly connected to the network. Check the cable connections in this
case.
The unit is not correctly integrated into the network. Check the IP address, subnet mask
and gateway address.
If necessary, back up the current configuration using the Download button on the
Maintenance configuration page (see Abschnitt 5.35 Maintenance, Seite 91).
Using a pointed object, press the Factory Reset button located below the orange terminal
block until the Connect LED flashes red (see Abschnitt 3.4 Connections on the Front
Panel, Seite 16). All settings will revert to their defaults.
Change the IP address of the VideoJet X10 if necessary.
Configure the unit to meet your requirements.
Installation and Operating Manual
Maintenance and Upgrades | en 109
V3.0 | 2007.09