Tool Specifications; Air Supply: Fittings, Hoses, Filters, Air Consumption, Regulators, Operating Pressure, Setting Correct Pressure - Bostitch TU-225-18HP Operation And Maintenance Manual

TOOL SPECIFICATIONS

All screws and nuts are metric.
MODEL LENGTH HEIGHT WIDTH WEIGHT
TU-225-18HP 9.07" (230.5mm) 7.80" (198.0mm) 1.58" (40.2mm) 2.43 lb. (1.1kg.)
FASTENER SPECIFICATIONS:
MODEL HEADLESS GAUGE FASTENER RANGE MAGAZINE
PIN SERIES CAPACITY
TU-225-18HP S100 18 5/8"- 1" (15-25mm) 100 PINS
TOOL AIR FITTING:
This tool uses a free-flow connector plug, 1/4" N.P.T. The minimum inside diameter should be .200" (5mm).
The fitting must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i. (4.9 to 7.1 kg/cm2). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
Model TU-225-18HP requires 1.86 cubic feet per minute (.053 cubic meters) of free air to operate at the rate
of 100 fasteners per minute, at 80 p.s.i. (5.6kg/cm2). Take the actual rate at which the tool will be run to
determine the amount of air required. For instance, if your fastener usage averages 50 fasteners per minute,
you need 50% of the tool's c.f.m. of free air which is required for running at 100 fasteners per minute.
-4-