Disassembly - Drain Pump - Bosch WFMC64 Repair Manual

7
To remove drain pumps:
• Remove front panel
• Loosen and remove hoses
• Disconnect green door latch release cord.
• Disconnect wire harness
• Carefully slide pump toward rear of washer,
then lift it out of washer (taking care to not
damage the four rubber feet).
Drain
pump
CAUTION: If opening drain pump
access cover, take care to not get
cut on front panel opening.
Current production pumps are beige
color – earlier WFMC pumps were black.
702_58300000133618_ara_en_a
Disassembly
Disassembly
Drain
pump
– Drain Pump
– Drain Pump
Note four mounting feet
HINT: Drain pumps are mounted on
four rubber feet to dampen vibration &
noise.
carefully slide them toward rear of
washers.
insert all four feet into notches in
washer base, then slide them forward.
Rear access is best
for most repairs.
To remove drain pumps,
To install them, carefully
Rev 0 (1/17/08)