Bosch WFMC64 Repair Manual page 18

18
WFMC Service Tips
WFMC Service Tips
WFMC64/84 washer test programs self-diagnose problems, including listing the last 8 fault codes
from the control module & the last 16 fault codes from the motor control. The tests are easy to
use, speeding up and simplifying diagnosing washer issues.
WFMC84
Entering & using WFMC64/84 test programs:
•
To reset, rotate cycle selector knob to Off position.
• To enter test program, push and hold Menu and Select buttons at the same time, then rotate cycle
selector knob ccw to Permanent Press Cold position. Hold Menu and Select buttons until P1:
Errors shows in display.
• To select tests, push Menu button (to scroll through tests) until desired test shows in display (P1 -
P17) - Start/Pause light will flash.
• To start tests, push Start/Pause button while its light is flashing -- light stays lit when test has
started. To end tests, push Menu button.
•
To exit test program, rotate cycle selector knob to Off position.
702_58300000133618_ara_en_a
WFMC64/84 Test Program
WFMC64/84 Test Program
P1:ERRORS
– Test Program (1B): Starting
– Test Program (1B): Starting
NOTE: Door locks
for all water fill and
drain tests.
If
HINT:
light
Start/Pause
doesn't come on for
some tests, door is
open. Turn off
washer, then close
door.
Rev 0 (1/17/08)