Bosch WFMC64 Repair Manual page 19

19
WFMC Service Tips
WFMC Service Tips
Viewing fault codes:
• WFMC32/33/53 displays alternate between fault code (e.g. E:01) & when fault occurred on in last 8 washes
(e.g. C:00) – shows C:00 if fault didn't occur.
• WFMC64/84 displays show fault code & when fault occurred on in last 8 washes (e.g. 0 - Er:01).
E:09
WFMC32/33/53 Displays
>START>MENU P1:ERRORS
1- Er:09
>START>MENU P1:ERRORS
1- dr:06
WFMC64/84 Displays
702_58300000133618_ara_en_a
– Test Program (2A): Fault Code Displays
– Test Program (2A): Fault Code Displays
WFMC32/33/53 fault code displays flash –
alternating between fault code (E:09) and wash
C:01
when fault occurred (C:01)
WFMC64/84 displays show fault codes (Er:09) and
washes when faults occurred (1)
After control module fault codes have been shown,
displays show motor control fault codes (dr:06) and
washes when faults occurred (1).
NOTE: Some control modules have been replaced since fault codes
stored in module or motor control can't be cleared. Modules are
operating properly and shouldn't be replaced to clear fault codes.
HINT: If "ERROR" shows on display and washer beeps while in
wash mode, check wire harness connections to control module and
from sensors (black wires), such as pressure sensor.
connections may cause this code.
TIP: Washers are designed to give a service history, not show
only latest fault codes. Since fault codes stored in module or
motor control can't be cleared, don't expect fault codes to be
reset to "0" when repairs are made.
Loose
Rev 0 (1/17/08)