Bosch WFMC64 Repair Manual page 17

17
WFMC Service Tips
WFMC Service Tips
WFMC32/33/43/53 washer test programs self-diagnose problems, including listing the last 8 fault
codes from the control module & the last 16 fault codes from the motor control. The tests are
easy to use, speeding up and simplifying diagnosing washer issues.
WFMC53
Entering & using WFMC32/33/43/53 test programs:
•
To reset, rotate cycle selector knob to Off position.
• To enter test program, push and hold Spin Selection and Delay Start buttons at the same time,
then rotate cycle selector knob ccw to Permanent Press Cold position. Hold Spin Selection
and Delay Start buttons until P:01 shows in display.
• To select tests, push Spin Selection button (to scroll through tests) until desired test shows in
display (P:01 - P:17) - Start/Pause light will flash.
• To start tests, push Start/Pause button while its light is flashing -- light stays lit when test has
started. To end tests, push Spin Selection button.
•
To exit test program, rotate cycle selector knob to Off position.
702_58300000133618_ara_en_a
WFMC32/33/43/53 Test Program
WFMC32/33/43/53 Test Program
P:01
– Test Program (1A): Starting
– Test Program (1A): Starting
NOTE: Door locks
for all water fill and
drain tests.
If
HINT:
light
Start/Pause
doesn't come on for
some tests, door is
open. Turn off
washer, then close
door.
Rev 0 (1/17/08)