Dividing the luggage compartment
Read and observe
on page 110 first.
The luggage compartment can be divided with the variable loading floor in the
lower and upper position.
›
Raise the rear of the variable loading floor by the handle
›
Push the rear edge of the variable loading floor into the grooves
direction of the arrow.
The variable loading floor is secured against movements in the grooves
Net partition
Introduction
This chapter contains information on the following subjects:
Using the net partition
Removing and refitting the net partition housing
WARNING
Be convinced that the crossbar of the net partition is firmly seated in the
■
recesses
» Fig. 118
on page 112.
E
The seat belts and the belt locks must be in their original position after
■
folding back the seat backrests – they must be ready to use.
The seat backrests must be securely locked in position so that no objects
■
in the luggage compartment can slide into the passenger compartment on
sudden braking – risk of injury.
Ensure that the rear seat backrests are properly engaged. Only then can
■
the seat belt for the middle seat reliably fulfil its function.
112
Using the system
Fig. 116
Dividing the boot with variable
loading floor
» Fig.
116.
A
in the
B
.
B
Using the net partition
Fig. 117 Open part of the roll-up luggage compartment cover / release
lever
112
113
Fig. 118 Net partition behind the front seats in the pulled-out state
Read and observe
The net partition can either be installed behind the rear seats or behind the
front seats.
Removing the net partition behind the rear seats
›
Fold out part of the roll-up luggage compartment cover
the arrow
» Fig.
117.
›
Pull out the net partition at the upper crossbar
» Fig.
118.
D
›
Hook the crossbar into one of the receptacles
on page 112 first.
from the housing
C
.
E
in the direction of
A