Table of Contents
Advertisement
Lid operation with the symbol button on the remote control key and the
button
C
Closed
Action
Lid
Opening
Stop
Closing
When the ignition is switched on, the operation of the lid does not function us-
ing the remote control key.
Operating the lid with the button
from the outside.
Operating the lid with the symbol button on the remote control key and the
button
does not work when a trailer is coupled to the vehicle.
C
Acoustic signals
Read and observe
and
The acoustic signals serve as a safety function and provide information about
the success of a performed action.
Signals
Importance
Open (using the button on the remote control key
or the button
Interrupted tone
Automatic closing of the lid
troduction
1 continuous tone
Force limiter
3 rising tones
Confirmation of the storage of the lid position
3 identical tones
fault
Adjusting/deleting the top lid position
Read and observe
and
Adjusting
›
Stop the lid in the desired position (electrically or manually).
›
Press and hold the button
» Fig. 41
B
Area
1
2
3
does not work if the vehicle was locked
C
on page 61 first.
» Fig. 42
on page 62 )
C
» page 61,
in section In-
on page 61 first.
on page 62 for longer than 3 seconds.
Storing the new position is confirmed with an audible signal.
Delete
›
Open
Carefully lift up the lid manually to the maximum opening position.
›
Lid
Press and hold the button
An audible signal sounds and the height which was originally set is deleted
from the memory, while the basic position of the top lid position is again set.
The top lid position is adjusted, for example, in the following situations.
›
When the space for opening the lid is limited (e.g. garage height).
›
For a more convenient operation, such as by a person's height.
The top position which is reached when the lid opens automatically, is always
lower than the maximum top position which can be reached when the lid is
opened manually.
The lid always opens to the height which was last stored.
Malfunctions
Read and observe
If the battery is disconnected and reconnected while the lid is open, it is nec-
essary to activate the system of the electric boot lid.
Activation means closing the lid slowly by hand. Thus, the end position of the
lid is stored under fully closed in secured lock.
Examples of operational malfunctions
Description of the malfunc-
tion
The lid cannot be lifted out
of the lock
The lid does not react to an
opening signal
The lid remains in the top
position
» Fig. 41
on page 62 for longer than 3 seconds.
B
and
on page 61 first.
Possible solutions
Emergency unlocking of the lid
Removing a possible obstacle (e.g. snow), re-
opening the lid
» page 62
Press handle
» Fig. 41
on page 62 and pull
A
the lid upwards
Manual closing of the lid
Unlocking and opening
» page 226
63
Advertisement
Chapters
Table of Contents
