Skoda Octavia 2014 Owner's Manual page 52

Average fuel consumption
The average fuel consumption is calculated since the last time the memory
1)
was erased.
If you wish to determine the average fuel consumption over a certain period of
time, you must set the memory at the start of the new measurement to
zero » page 48.
After erasing the memory, no fuel consumption data will appear for the first
100 m driven.
The indicated information is updated continuously while you are driving.
With G-TEC vehicles, the average consumption of fuel currently being used is
displayed.
Current fuel consumption
You can use this information to adapt your driving style to the desired fuel
consumption .
1 )
The display appears in litres/hour
ing driven at a low speed.
With G-TEC vehicles, the current consumption of fuel currently being used is
displayed.
Oil temperature
If the engine oil temperature is in the range 80-110 °C, the engine operating
temperature is reached.
If the oil temperature is lower than 80 °C or above 110 °C, avoid high engine
revs, full throttle and high engine loads.
If the oil temperature is lower than 50 °C or if a fault in the system for check-
ing the oil temperature is present,  are displayed instead of the oil tempera-
ture.
Warning against excessive speeds
Set the speed limit, for example, for the maximum permissible speed in
town » page 50.
1)
The units for the displayed consumption are set in the Infotainment
tions, chapter Device settings.
2)
On some models in certain countries, the display appears in --,- kilometres/litres if the vehicle is station-
ary.
3)
In natural gas mode.
or in kg/h if the vehicle is stationary or be-
2) 3)
» Infotainment operating instruc-
Traffic sign recognition
The display can show up to three of the following traffic signs simultaneously.
›
Speed limits (including additional signs).
›
Overtaking prohibited.
Further information » page 164, Traffic sign recognition.
Current driving speed
The current speed displayed is identical to the display on the speedometer
» Fig. 22 on page 31.
3
Average speed
The average speed since the memory was last erased is displayed in km/hour .
To determine the average speed over a certain period of time, set the memory
to zero at the start of the measurement
After erasing the memory, no data will appear for the first 300 m driven.
The indicated information is updated continuously while you are driving.
Distance travelled
The distance travelled since the memory was last erased is displayed.
If you want to measure the distance travelled from a particular moment in time
on, at this moment, reset the memory by setting the button to zero
The maximum distance indicated is 9999 km. The indicator is automatically set
back to zero if this period is exceeded.
Driving time
The time travelled since the memory was last erased is displayed.
If you want to measure the time travelled from a particular moment in time on,
at this moment, reset the memory by setting the button to zero
The maximum distance indicated is 99 hours and 59 minutes. The indicator is
automatically set back to zero if this period is exceeded.
Convenience consumers
There, the total consumption of all consumer comfort in l / h is displayed.
» page 48.
» page
» page 48.
Information system
48.

49