Install The Drain Hose - KitchenAid KUDD03DT Installation Instructions Manual

Option 2: Top attachment
1. If the top attaching brackets are used, open the top drawer
slightly.
2. Screw the top attaching brackets to the underside of the
counter with two #8 Phillips head screws.
IMPORTANT: The top attaching brackets can accommodate
a maximum 3/4" (19 mm) vertical gap.
3. Close the top drawer.

Install the Drain Hose

Option 1: Sink drain waste tee connection
1. Route the drain hoses as shown and press the hoses into
the drain hose support.
2. Decide if the drain hoses need to be trimmed. If they do,
trim them.
3. Slip a wire clip over each drain
hose. Push the hoses into the
drain hose connector firmly,
5 clicks.
4. Position the wire clips between
the two positioning ribs on the
drain hose connector.
5. Attach the drain hose connector to the waste tee using
the supplied hose clamp.
6. Attach the drain hose support bracket to the cabinet with
a #8 Phillips head screw at the height shown below.
NOTE: The drain hose connector must not support the weight
of excess hose length. Keep hoses as fully extended as
possible.
drain hose
support
27-1/2" – 32-1/4"
(70 cm – 82 cm)
10
top attaching bracket
wire clip
wire clip
drain hose
connector
waste tee
waste
water supply
Option 2: Garbage disposal connection
1. Route the drain hoses as shown and press the hoses
into the drain hose support.
2. Decide if the drain hoses need to be trimmed. If they do,
trim them.
3. Slip a wire clip over each drain
hose. Push the hoses into the
drain hose connector firmly,
5 clicks.
4. Position the wire clips between
the two positioning ribs on the
drain hose connector.
5. Attach the drain hose connector to the garbage disposal
using the supplied hose clamp.
6. Attach the drain hose support bracket to the cabinet with
a #8 Phillips head screw at the height shown below.
NOTE: The drain hose connector must not support the
weight of excess hose length. Keep hoses as fully extended
as possible.
drain hose
support
valve
Option 3: Air break connection
1. Route the drain hoses as shown.
2. Decide if the drain hoses need to be trimmed. If they do,
trim them.
3. Slip a wire clip over each drain
hose. Push the hoses into the
drain hose connector firmly,
5 clicks.
4. Position the wire clips between
the two positioning ribs on the
drain hose connector.
wire clip
wire clip
drain hose
connector
6" (15.2 cm)
minimum
garbage
disposal
waste
water supply
8" (20.3 cm) min. bend
radius from valve
wire clip
wire clip
drain hose
connector