Stealth Bike Care; Cleaning; Storage - Stealth bomber Owner's Manual

STEALTH BIKE CARE

WARNING: Excessive water exposure will void your warranty. This is an electric bike and all care should be taken to
Stealth Electric Bikes can be ridden in a multitude of environments and weather conditions. While these bikes are water
resistant, care must be taken in exceptionally wet conditions and the bikes must never be submerged in water in any way.
Rain or snow may cause the metal on your e-bike to corrode and also affect the electrical system.
WARNING: Riding your Stealth Bike in sand will void your warranty. Due to the demands of deep sand on the power
train of the bike, we advise that this bike should not to be ridden in sand.

CLEANING

High pressure washers should not be used for cleaning. While the bikes are very well sealed, water ingress may occur as a
result of high pressure water being forced past seals and into electronic components. The preferred method for cleaning is
with a sponge and warm soapy water.

STORAGE

If the bike is going to be stored for periods of more than 3 weeks, it is preferred that the battery is disconnected from the
bike. During prolonged periods of inactivity, the battery should be connected to the charger for 1 hour every month in
order to prolong the life of the battery.
Do not expose your bike to extreme highs or lows of temperature. Ideally the bike should be stored at temperatures
between 10˚C and 40˚C.
Avoid storing the bike in wet or damp areas or areas that are prone to extended periods of direct sunlight.
If you have to ship your bike, make sure it is properly packed and protected to avoid damage.
TRANSPORTATION
avoid excessive water exposure.
STEALTH ELECTRIC BIKES 2013 OWNER'S MANUAL
Before storage spray CRC 5.56 into
the motor through the breather
hole (shown on left). Very carefully
lay the bike on its side and rotate
the wheel spraying the CRC into
the motor for two full revolutions.
Once complete, spin the wheel by
hand 10-15 rotations.
V 1.2 PAGE | 8