Troubleshooting - Stealth bomber Owner's Manual

TROUBLESHOOTING

In the event that your Stealth Bike will not go, or runs roughly, the following chart may help to quickly fix the problem. In
other instances you will require the assistance of your dealer. If in any doubt, contact your dealer.
Problem
Bike is not running smoothly
or there is a strange noise
Bike is switched on but won't
run
Screen not turning on
Gears not changing smoothly
Battery not charging
Clicking sound from the
gearbox when rolling or
pedalling backwards
Cause
Connectors have dislodged or have
water ingress/corrosion
Possible hall sensor malfunction
Possible controller malfunction
Loose/corroded connectors or wires
Water in connectors
Possible damaged hall sensor
BMS needs to be reset
Possible problem with key
switch/connectors
Possible problem with screen connector
Battery not charged
Improper gear shifting
Gear shifter or cables damaged or
fouling
BMS Shut down
Improper connection at charge port
This is 100% normal and is nothing to be
concerned about. Some gears are more
prone to this than others but again it is
nothing to be concerned about
STEALTH ELECTRIC BIKES 2013 OWNER'S MANUAL
Action
Visually inspect all wires to ensure that there
are no breakages or wear
Check all connectors beneath battery pack.
Ensure they are dry. Use an air gun to expel
water if moisture is found
Check large 3 pin connector to motor
Check small 5 pin connector to motor
Refer to dealer if damage is found
Refer to dealer
Refer to dealer
Visually inspect all wires to ensure that there
are no breakages or wear
Check all connectors beneath battery pack
Check large 3 pin connector to motor
Check small 5 pin connector to motor
Refer to dealer
Follow BMS reset procedure found below
Inspect key switch and connectors and check
for continuity
Inspect screen and connectors
Plug charger into bike
Make sure that when selecting each gear, a
positive shift/click is heard each time.
Ensure that when shifting, pressure is released
from the pedals slightly as the next gear is
selected
Inspect gear shifter and cables for damage or
fouling
Remove cover, disconnect and reconnect large
battery connector
Check continuity between battery and charge
port
No action required
V 1.2 PAGE | 30