Assembling Your Bike; Out Of The Crate - Stealth bomber Owner's Manual

ASSEMBLING YOUR BIKE

WARNING: Electricity has the potential to kill. Do not tamper with the electrical components of the bike without
CAUTION
Working on your bike can be hazardous in ways that may not appear obvious. The presence of others in your work
environment can contribute and increase the likelihood of such accidents. Please take every precaution to maximise safety
when working on or around your bike.
Ensure that the power is always switched off and/or, the battery/motor cables are disconnected.
Always ensure that hands are dry and the work area is free of water.

OUT OF THE CRATE

You will need to assemble some components of the bike before riding. The following components should be assembled in
order.
1. Install the handlebars
CAUTION
• Ensure that cables and wire are free and not fouling on any part of the frame or any other components.
•
Correct tightening of fasteners requires a calibrated torque wrench. Torque specifications can be found in the
Appendix 1 of this manual.
The handlebars come from the factory with all controls installed and ready.
I. Remove the 4 bolts around stem cap using a 6mm Allen key.
II. Remove cap from stem.
III. Gently and carefully cut tape securing forks to stem and remove bubble wrap.
IV. Install handlebars on stem making sure that wires and cables are moving freely and not fouled in any way.
V. Loosely reinstall the end cap on the stem using the same 4 bolts.
VI. Check alignment of handlebars and preferred riding position.
VII. Evenly tighten bolts to correct tension (see Appendix 1 for recommended torque values).
authorisation from a Stealth technician or dealer.
STEALTH ELECTRIC BIKES 2013 OWNER'S MANUAL
V 1.2 PAGE | 12