Fighter; Cycle Analyst - Stealth bomber Owner's Manual

Fighter

WARNING: The pressure on the pedals must be released when shifting gears. Failure to do so may damage your

CYCLE ANALYST

How to read your Cycle Analyst (basic version)
After every charge, reset the display by holding down the right button for 3 seconds. "Reset" or "Trip Reset" will flash on to
the screen, depending on CA version, and this will reset the trip statistics from your previous ride.
Assuming that your CA is on the main screen, here's what you need to know.
Once you begin to ride you will see the Watts (W) on the bottom left hand corner of the screen begin to increase. This is an
instantaneous reading of how much power you're using (discharge rate). The more the throttle is turned, the higher the
Watts will be.
The bottom, right hand side of the screen will alternate between Amp-hours (Ah) and distance (m or km) every few
seconds.
transmission.
The Fighter is fitted with a 2-speed internally geared bottom bracket. To
shift gears, kick the button found on the cranks to the right for high range
and to the left for low range.
The Cycle Analyst displays important real-time information such as
power consumption, battery level, speed and distance.
It can also be used to limit your maximum speed and maximum power
output.
Refer to the Cycle Analyst manual for detailed instructions of how to
use the Cycle Analyst functions. As Cycle Analyst is turned on it
displays its version number, refer to corresponding manual.
STEALTH ELECTRIC BIKES 2013 OWNER'S MANUAL
V 1.2 PAGE | 20