Doors - Heat & Glo SL-550BE Owner's Manual

C. Doors
It's very important to know what kind of a door and what
kind of fi nishing material is going to be used on the fi re-
place. The table below shows the door models and the
fi nishing material thickness allowed. For an inside fi t
there is an available template to assist with sizing the
fi nishing material.
UNITS AND
SL-550BE, SL-550BE-IPI (550-Template)
TEMPLATE PART #
FINISH MATERIAL
DOOR FIT
THICKNESS
Aero-32 Inside 4 inches Max.
Chad-32E Overlap 1 inch Max.
Chad-32E Inside 1-4 inches
Halston-32E Overlap 1 inch Max.
Halston-32E Inside 1-4 inches
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
Stop fi nishing material fl ush with fi replace surround opening.
Figure 11.6 Aero Door
FRONT FACE OF FIREPLACE
DOOR
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 11.7 Overlap Fit Door (Chad and Halston)
46
SEE
X Y
FIGURE
11.6 N/A N/A
11.7 N/A N/A
11.8 32-3/8 in. 30-3/8 in.
11.7 N/A N/A
11.9 32-3/8 in. 30-3/8 in.
DOOR
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
1 in. MAX
FINISHING MATERIAL
(TOP EDGE)
Heat & Glo • SL-550BE, SL-550BE-IPI • 2114-900 Rev. H • 2/08
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
(Includes 1/8 in. opening each side of door)
Finishing material between 1 and 4 inches thick.
Refer to Table 1 for X and Y dimensions.
Figure 11.8 Inside Fit Door (Chad)
FINISHING
MATERIAL
*IF FINISHING MATERIAL IS THICKER THAN
2 IN., DOORS WILL ONLY OPEN
AS FAR AS PICTURED
X
(Includes 1/8 in. opening each side of door)
Finishing material between 1 and 4 inches thick.
Refer to Table 1 for X and Y dimensions.
Figure 11.9 Operable Hinge Door (Halston)
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
DOOR
Y
X
FINISHING
MATERIAL

DOORS

Y