Flexible Co Button Assignment (005) - Panasonic KX-TD500 User Manual

4.3.5 Flexible CO Button Assignment (005)

You can change the flexible CO buttons of all PTs in the system to the function buttons listed on the
next page. For example, if someone's telephone has more CO buttons than available CO lines, you
may change an unused CO button to a One-Touch Dialling button.
Default: For all PTs – CO button 1 = Loop-CO; Ring tone type 2
Other CO buttons = Not Stored.
<Extension Selection>
0 0 5
Dial 005.
<Programming>
(CO)
Press CO.
*Please refer to the table on the next page for information on "button code" and "parameters."
<Cancelling>
(CO)
Press CO.
• The number of CO buttons available for each PT varies depending on the telephone type.
• If you press the same CO button twice consecutively during <Programming>, you can select
a desired ringer frequency for the CO button from eight types of ring tones. When you enter
the tone type number (1 through 8), you will hear the selected tone type until STORE is
pressed. This selection is possible only for the CO buttons that have been assigned to
Single-CO, Group-CO, Loop-CO, PDN or SDN.
Customising Your Phone & System
NEXT
Press NEXT.
button code*
Enter button code. Enter parameters,
if required.
2
STORE
Press STORE.
Enter 2.
To continue
4.3 Customising Your System (User Programming)
<Programming>
extension no.
Enter extension
number (3-4 digits).
SELECT
Press SELECT.
parameters*
STORE
Press STORE.
To continue
To end
<Cancelling>
Press END.
To programme another extension
END
237