IBM eServer xSeries 455 Type 8855 Hardware Maintenance Manual And Troubleshooting Manual page 100

Complete the following steps to install an adapter:
1. Read the safety information beginning on page 215 and "Installation guidelines"
2. Disable the PCI-X slot through your operating system before you insert or
3. Open the top cover.
4. Follow the cabling instructions, if any, that come with the adapter. Route the
5. Follow the instructions that come with the adapter to set jumpers or switches, if
6. Install the adapter:
90
IBM xSeries 455 Type 8855: Hardware Maintenance Manual and Troubleshooting Guide
on page 77.
Attention: When you handle static-sensitive devices, take precautions to
avoid damage from static electricity. For details about handling these devices,
see "Handling static-sensitive devices" on page 78.
remove a PCI or PCI-X adapter.
Note: Some operating systems do not support the enabling and disabling of a
PCI-X slot. If your operating system does not support this function, turn
off the server and peripheral devices, and disconnect the power cords
and all external devices from the back of the server before proceeding.
adapter cables before you install the adapter.
any.
Adapter guide
a. If you are installing a full-length adapter, open the blue adapter guide by
lifting the front edge, as shown in the illustration.
b. Push the orange adapter-retention latch toward the rear of the server, and
open the tab.
c. Remove the expansion-slot cover.
Tab
PCI-X
divider
Attention
LED
Power
LED
Adapter
retention
latch