Table of Contents
Advertisement
FIGURE 4
STAND II
ADJUSTING KNOB (59)
3.
With assistance, set the Tile Saw
upright. (See Figure 4.)
4.
The Adjusting Knob (59) is located at the
bottom of Stand II (64). Turn the Adjusting
Knob clockwise or counterclockwise
to keep the Tile Saw stand balanced
evenly on the floor. (See Figure 4.)
FIGURE 5
MOTOR
BOLTS (98),
SUPPORT
(111)
WASHERS (95),
WASHERS (94)
5.
Attach the Handle (38) to the Motor Support
(111), using the Bolts (98), Spring Washers
(95), and Washers (94). (See Figure 5.)
Item 97360
For technical questions, please call 1-888-866-5797.
(64)
ADJUSTING
KNOB (59)
HANDLE
(38)
SPRING
To Attach the Knobs:
FIGURE 6
Knob
(22)
1.
Place a Washer (102), Lock Washer (95) and
another Washer (102) onto each of the two
Knobs (22).
(See Figure 6.)
2.
Align the Right Rail Stand (41) as
shown in Figure 6, above.
3.
Remove the shipping screw and
attach the Knob (22) through the slot
in the Right Rail Stand (41) and into
the threaded hole as shown.
4.
Repeat for the Left Rail Stand
(24) and the other Knob (22).
5.
Secure Knobs.
Right Rail
Stand (41)
slot
Page 9
Hide quick links:
Advertisement
Table of Contents
