Chicago Electric 97360 Owner's Manual & Safety Instructions page 13

Breaker by pushing in the button. Then,
turn the Power Switch to its "ON" position
to resume cutting. (See Figure 11.)
Note: If the Pump fails, first try clearing the Filter
of debris and make sure it is not plugged. If Pump
still does not operate properly, it must be replaced.
To Make A Miter Cut:
SCALE
RAIL
(49)
BUTTERFLY KNOB
(47)
FIGURE 13
1. Loosen the Butterfly Knob (47) on the
Angle Cutting Guide (46) and position the
Angle Cutting Guide at the desired angle
to the Scale Rail (49). Then, retighten the
Butterfly Knob (47). (See Figure 13.)
2. For a 45 degree cut, use the 45° Angle
Cutting Guide (65) that is included as
an accessory item. Hold the tile against
the Guide and slide the Guide down the
Scale Rail (49). (See Figure 13.)
3. To cut the tile, follow the same
procedure as outlined in the section
"To Make A Straight Cut".
Item 97360
ANGLE
CUTTING
GUIDE (46)
45° ANGLE
CUTTING
GUIDE (65)
For technical questions, please call 1-888-866-5797.
To Make A Bevel Cut;
LEFT END
KNOB
(22)
FIGURE 14
1. Loosen the Knob (22) on each end of the
Tile Saw. Also loosen 2 Bolts, (located
on lower end of each Rail Stand (24 &
41). Tilt the Slide Rail (26) to the desired
angle as indicated on the Angle Scale
(43). Then, retighten the two Knobs,
and two bolts. (See Figure 14.)
2. To cut the tile, follow the same
procedure as outlined in the section
"To Make A Straight Cut".
RIGHT END
KNOB
(22)
Page 13