Metric System ~ Imperial System - Tunturi GO BIKE 50 User Manual

EN
Constant Watt Program (WATT)
1. Turn the SELECTION dial to set the target resistance. Touch the ENTER button
to confirm.
2. Set the time, the distance, the energy consumption and the heart rate limit as
described in the section "Manual program".
3. Touch the START/STOP button to start the workout. If you have set target
values, the values start to count down.
4. The resistance is adjusted depending on your speed, so that your target
resistance will be reached and maintained.
5. Manually change the target resistance during the workout: Turn the SELECTION
dial to set the resistance.
Recovery
The recovery heart rate can be calculated after a workout. The recovery heart rate
can only be calculated if the heart rate measurement is activated and the heart rate is
shown on the display. The recovery heart rate can range from F1 to F6. F1 is the
best recovery heart rate.
1. Touch the RECOVERY button. After 60 seconds, the display shows the recovery
heart rate.
2. Touch the RECOVERY button again to go back to the main menu.
Body fat
1. Touch the BODY FAT button.
2. Hold both hands on the handgrips for 8 seconds. Make sure that your hands are
constantly touching the hand pulse sensors. The display shows the body mass
index (BMI) and the body fat percentage.
3. Touch the BODY FAT button again to go back to the main menu.

Metric system ~ Imperial system

For speed and distance, metric units or imperial units can be used as default units of
measurement.
1. Locate the KM/ML switch on the rear of the console.
2. Move the KM/ML switch to "KM" to use the metric system as the default system
of measurement.
3. Move the KM/ML switch to "ML" to use the imperial system as the default system
of measurement.
24 BIKE 50