Valet Mode - Directed Electronics PS-3655E-FM User Manual

Note1: The engine will continue running until the user re-enters the vehicle or until the expiration of
the engine run time.
Note2: If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will enter Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.

Valet Mode

When the vehicle is in Valet Mode, the remote starter and alarm functionalities are disabled. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from
being remote-started accidentally.
Any of the following features will put your remote car starter into Valet Mode:
Ignition Valet: This feature allows you to put your system into Valet Mode by
using the ignition key.
Remote valet: This feature allows you to put your system into Valet Mode by
using the transmitter.
To put the system into Valet Mode
To put the system into Valet mode using the KEY (Ignition Valet Mode):
1. Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2. The parking lights will flash three times.
3. Turn the ignition OFF.
4. The LED on the antenna will come ON solid to indicate that the vehicle has successfully
entered Valet mode.
To put the system into Valet mode using the TRANSMITTER (Remote Valet Mode):
1. Press the and buttons simultaneously until the parking lights flash three times.
2. The LED on the antenna will come ON solid to indicate that the vehicle has successfully
entered Valet mode.
To put the system out of Valet Mode
To put the system out of Valet mode using the KEY (Ignition Valet Mode):
1. Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2. The parking lights will flash twice.
3. Turn the ignition OFF.
4. The LED on the antenna will flash quickly to indicate that the vehicle is now out of Valet
mode.
To put the system out of Valet mode using the TRANSMITTER (Remote Valet Mode):
1. Press the and buttons simultaneously until the parking lights flash twice.
2. The LED on the antenna will flash quickly to indicate that the vehicle is now out of Valet
mode.
The system will warn you if someone attempts to remote start the vehicle while in Valet Mode:
The parking lights will:
Turn ON then OFF; then
Flash twice.
P.8
User Guide