Advertisement
Available languages
Available languages
UNPACKING
After removing all parts and hardware pack from the top of the shipping box, and when the only part showing is
the grill head, use a box cutting knife to slice down the sides of the box. Be careful of staples along shipping box
edges.
Remove the steel and cardboard corner supports from the box and the styrofoam side pieces from the grill head.
Open grill lid and remove all packaged parts and packing material.Allow grill head to rest on cardboard until
placing grill head on cart in Step 10.
WARNING: Assemble the grill on a flat level surface. Compare the parts and hardwarewith the list and
diagrams. Do not attempt assembly if any part is missing or damaged.
Use the supplied wrench to attach the casters to the bottom panel as shown below. Attach the two
locking casters at the back of the grill. After attaching all casters, turn the bottom panel over.
Locking Caster
Bottom Panel
Caster
Attach the door magnet to the holes in the front of the bottom panel with 2 screws each. Do not fully
tighten at this time.
Bottom Panel
5/32-32x 1/2" Screw
"_
Qty.2
Door Ma
15
Advertisement
