GMC 1989 Light Duty Truck Repair Manual page 323

Unit repair manual
Table of Contents

Advertisement

1. C over
2. D iap hrag m
3. R ese rvo ir
4. G ro m m e t
5. Q u ic k Take-Up Valve
6
. S p rin g
7. S p rin g R e ta in e r
8
. P rim ary Seal
9. S e c o n d a ry P isto n
10. S e co n d a ry Seal
11
. S nap R ing
12. P rim a ry P is to n A s s e m b ly
13. B ody
CAUTION: In the following step if air pressure is
used to remove the secondary piston, place the
open end of the cylinder bore approximately 25
mm (1-inch) from a padded workbench or other
surface to catch the piston when it comes out
of th e bore. A pply low air pressure very
carefully to ease the piston out of the bore.
Never point the open end of the bore at anyone
when applying air pressure. The piston may
come out of the bore with considerable force
and cause personal injury.
5. Secondary piston (28).
• W ith the rear port plugged apply a small
amount of air pressure to the front port.
6
. Secondary seals (29) from the secondary piston (28)
(figure 16).
7. Spring retainer (26) and primary seal (27).
8
. Spring (25).
9. Tube seats (if necessary) (figure 17).
• Thread a self-tapping screw into the tube seat
and remove with locking jaw pliers.
Figure 9— Composite Master Cylinder Components
Ijji
Clean
All the metal parts in denatured alcohol.
All the rubber parts in clean brake fluid.
Stained or discolored cylinder bore with crocus
cloth.
I ?
Inspect
Diaphragm for cuts, cracks, or a swollen condition.
Cylinder bore for scoring or corrosion. If corrosion is
present, replace the cylinder. Do not attempt to hone
the bore.
Install or Connect (Figure 14)
• Lubricate all the seals and cylinder bore with clean
brake fluid.
1. Spring (25).
2. Primary seal (27) and spring retainer (26) onto the
secondary piston (28) (figure 16).
3. Secondary seals (29) onto the secondary piston
(28).
4. Secondary piston (28).
BRAKES 5-5
F-00769

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents