(6)Click Finish in the Completing the New Hardware Wizard dialog.
Operating Procedure
1.
Plug the burner board USB port into the PC, Plug the connector cable into RS232 port of the projector.
2.
Turn on the projector, Press the direction keypad following the actions below: Up twice, down twice, left once,
right once, left once, right once(▲▲▼▼◄►◄►),press the MENU button, Enter the engineer mode, Setting
PCS[1].
Double-click WriterSpiRomForL0046.
3.
ViewSonic Corporation
31
Confidential - Do Not Copy
PRO8100-1