Mitel 6800i Series Release Notes page 30

Mitel 6800i Series SIP Phones 4.0.0 SP1 Release Notes
"#71", the softkey value should be defined with the two specific FACs separated by a
semi-colon (i.e. "#61;*61" or "#61;#71" respectively).
Notes:
1. If the Deactivation FAC is not specified after the semi-colon (e.g. "#61;"), the
2. The IP phones support Executive Call Filtering Activation/Deactivation FACs
Irrespective of a defined or undefined key value, when the Filter softkey is pressed, Executive
Call Filtering will be activated and the softkey's corresponding LED will be lit. When the Filter
softkey is pressed again, Executive Call Filtering will deactivate and the softkey's corresponding
LED will turn off.
Note: Upon a reboot, the initial state of the Filter softkey LED will correspond to the
Executive Call Filtering state configured on the call manager.
Configuring the Filter Softkey on the Executive's Phone Using the Mitel Web UI
Use the following procedure to configure the Filter Softkey on the Executive's phone using the
Mitel Web UI:
1. Click on Operation->Softkeys and XML.
or
Click on Operation-> Programmable Keys.
or
Click on Operation->Expansion Module Keys.
2. Select a key that you want to use as a Filter activate/deactivate key.
3. In the "Type" field, select "Filter".
4. In the "Label" field (6867i and 6869i only), enter a label to apply to this key (e.g. Filter).
5. (Optional) In the "Value" field, enter the Executive Call Filtering Activation FAC (e.g. #61)
or both the Executive Call Filtering Activation and Deactivation FACs followed by a semi-co-
lon (e.g. #61;*61).
6. In the "Line" field, select the line for which you want to use the key functionality.
7. Click Save Settings to save your settings.
Configuring the Filter Softkey on the Executive's Phone Using the Configuration Files
To configure the Filter softkey on the Executive's phone using the configuration files, you must
enter "filter" for the key type. For the label (6867i and 6869i only), enter a key label to assign
to the Filter key (e.g. "Filter"). Defining the value is optional. If you prefer to toggle Executive
Call Filtering using an FAC call, enter in the Executive Call Filtering Activation FAC (e.g. "#61")
or both the Executive Call Filtering Activation and Deactivation FACs followed by a semi-colon
(e.g. "#61;*61") for the value. For the line setting, enter the line number for which you want to
use the key functionality.
26
phone will ignore the semi-colon and behave as if only the Activation FAC was
defined (i.e. the phone will automatically assume that the Deactivation FAC is
in the same format but sequentially one number above the Activation FAC.
that contain the prefix "#" or "*".