Mitel 6800i Series Release Notes page 19

PARAMETER
ring splash frequency
ring splash volume
Configuring the Play A Ring Splash Setting Using the Mitel Web UI
Use the following procedure in the Mitel Web UI to configure the Play a Ring Splash setting:
1. Click on Basic Settings ->Preferences ->Directed Call Pickup Settings
2. Using the Play a Ring Splash drop-down menu, select the preferred setting. Options
include:
• Disabled
• Enabled
• Enabled also in call
3. Click Save Settings to save your changes.
Note: This global setting is not dynamic. Changes to this setting will take effect only
after the phone has been rebooted
Configuring BLF and BLF/List Ring Splash Support Using the Configuration Files
Use the following parameters to configure the BLF and BLF/List ring splash feature:
PARAMETER
play a ring splash
DESCRIPTION
FORMAT
DEFAULT VALUE
RANGE
EXAMPLE
DESCRIPTION
Indicates the frequency interval (in seconds) when the "...keyN ring
splash" parameter is set to a "periodic" alerting pattern.
Indicates the volume of the ring splash from 1 (loudest) to 9 (softest) when
the "...keyN ring splash" parameter is set to a "low volume" alerting
pattern.
CONFIGURATION FILES
startup.cfg, <model>.cfg, <mac>.cfg
Enables or disables the playing of a short ring splash when there is an
incoming call on a BLF or BLF/List-monitored extension.
Integer
0 (Disabled)
0 - 2
0 (Disabled)
1 (Enabled for idle state only)
2 (Enabled for idle state and active call state)
Note: This global parameter is not dynamic. Changes to this parameter will
take effect only after the phone has been rebooted.
play a ring splash: 2
Additional Information
15