Table of Contents
Advertisement
WDV See-thru Gas Fireplace
LIGHT INSTALLATION
1. Remove the front floor screen frame by unfastening
the eight (8) screws securing the front and sides.
2. Install the six (6) halogen light bulbs provided. Do not
touch light bulbs directly with fingers.
3. Replace the front floor screen frame. Be sure wires do
not get pinched below the light channel.
4. Repeat procedure for lights on opposite side.
Floor Screen
Frame
Pilot is
Located
in Center
Halogen Light
Bulbs
Figure 38 -
Install Light Bulbs
FP2434
STONE & GLASS PLACEMENT
replace light bulbs
1. For best results, spread glass evenly over the entire floor
and burner making sure the glass is not too heavy over
the burner ports (single layer only). Keep rear vent area
open to allow air to circulate under the stones. Figure
39
2. Place the stones randomly in front of and behind the
burner ports. CAUTION: Do not allow stones to sit
directly on burner ports or in flame. Figure 39
3. Turn burner on and adjust glass over the ported area
to achieve an even, clean flame. Page 41, Figure 58
4. Replace glass frame and access door in reverse order
of removal.
28
Screws
FP2435
FIREPLACE INSTALLATION
GLASS ONLY PLACEMENT
NOTE: Two (2) bags of glass are supplied with the 500
Series fireplaces. Both bags should be used to cover the
entire floor and burner. Three (3) bags of glass are supplied
with the 600 Series fireplaces. It is not necessary to use
the entire 3rd bag of glass provided. Too much glass can
cut off the proper amount of air the burner needs to burn
clean. This may cause sooting.
1. Spread glass evenly in one layer over the entire floor
and burner. It is important to not have the glass too
heavy on ported area (single layer only). Keep rear vent
area open to allow air to circulate for a clean flame and
appearance.
2. Turn burner on and adjust glass over ported ares to
achieve an clean flame.
3. Replace glass frame and access door in reverse order
of removal.
Firebox
Perimeter
Example of Stone Placement
FP2434
stone placement
Figure 39 -
Stone Placement
FP2702
rock and stone place
Rear
Burner
Vent
Surface
20306746
Advertisement
Table of Contents
