Table of Contents
Advertisement
FIREPLACE INSTALLATION
GLASS FRAME REMOVAL
NOTE: If the safety barrier is in place, you must first remove
it before you remove the glass frame. To remove the
barrier, simply lift up and pull out until the tabs are clear
of their corresponding slots on the firebox. Then proceed
to remove the glass frame by following the steps below.
1. Remove the front access door by lifting up and sliding
the two (2) spring hinge pins inward and lifting off.
2. Rotate the three (3) cam levers in the lower access area
90° clockwise.
3. Tilt glass away from unit. Lift glass frame up and away
from unit.
Glass Frame
Safety Barrier
FP2431
Figure 37 -
remove glass 1
Remove Glass Frame
20306746
A barrier designed to reduce the risk of burns from
Front Access
Door
Spring Hinge
Pin
WDV See-thru Gas Fireplace
DANGER
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
the hot viewing glass is provided with this
appliance and shall be installed.
DANGER
Un panneau vitré chaud peut
Laissez refroidir le panneau
Ne laisser jamais les enfants
Cam Levers
toucher le panneau vitré.
Une barrière visant à réduire le risque de brûlure
par le hublot chaude est fournie avec cet
appareil et doit être installé.
FP2432
open cam levers
FP2433
lift glass
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
causer des brûlures.
vitré avant d'y toucher.
27
Advertisement
Table of Contents
