Table of Contents
Advertisement
GENERAL INSTALLATION INFORMATION
BEFORE YOU START
Read this homeowner manual thoroughly and follow all
instructions carefully. Inspect all contents for shipping
damage and immediately inform your dealer if any damage
is found. Do not install any unit with damaged, incomplete,
or substitute parts. Check your packing list to verify that all
listed parts have been received.
The following factors should be taken into consideration:
•
This insert should have sufficient access for its safe
operation and maintenance.
•
The flow of combustion and ventilation air must not be
obstructed.
•
Minimum clearances to combustibles, such as mantels,
must be maintained. Refer to Pages 8 and 9, Figures 3
and 4.
•
Never obstruct the front opening of the insert.
•
Do not install in the vicinity where gasoline or other
flammable liquids may be stored.
•
These units can be installed in a bedroom. Refer to
National Fuel Gas Code ANSI Z233.1/NFPA 54 (current
edition), the Uniform Mechanical Code (current edi-
tion), and Local Building Codes for specific installation
requirements.
IMPORTANT: Your direct vent insert was designed to
be installed in an existing wood burning fireplace. The
location and clearances are subject to local building
codes.
INSERT APPLICATIONS
Before installing the gas fireplace insert, consider the
functioning needs of the fireplace. Confirm the size of the
fireplace cavity, the design of the chimney, and the avail-
ability of the gas supply and electricity for the insert fan.
IMPORTANT: Your direct vent insert is designed to be
only vented vertically with a minimum height of 10 feet.
When the unit is installed into a wood burning fireplace,
the minimum distance the mantel can be placed above the
fireplace is governed by local building codes applicable to
wood burning fireplaces. Consult local authorities having
jurisdiction for these clearances. The underside of the
mantel will become warm. Use only finishes which are heat
resistant and do not discolor.
20306752
Your remote control receiver must "learn"
the signal code from your hand-held trans-
mitter. This operation should be performed
with power applied to the fireplace but before
the fireplace is installed into the fireplace
cavity. Refer to "Remote Transmitter Learn
Function" on Page 30.
The dimensions shown on Pages 8 and 9, Fig-
ures 3 and 4, are minimum clearances to main-
tain when installing this heater. Follow these
instructions carefully to ensure safe installation.
Failure to follow instructions exactly can create
a fire hazard.
ICFDV30 Fireplace Insert
7
Advertisement
Table of Contents
Troubleshooting
