Loading The Bmp Lithium Ion Battery Pack - Brady BMP 51 Quick Start Manual

6 Setting Up the Printer

Loading the BMP Lithium Ion Battery Pack

1. On the backside of the
printer, using your thumb,
pull the door release
latch downward, then
swing the battery
compartment door up
and out. (The door will
come off.)
Adapter
The printer can be powered through a designated AC power adapter. When the adapter
is plugged in, it will also charge the BMP Lithium Ion Battery Pack if one is inserted in
the battery compartment. (It will NOT charge AA rechargeable batteries.)
Use only the 18 VDC, 3.3A, Brady AC/DC adapters, shown below, for supplying
power to the BMP
1. Insert the round end of the adapter cable
into the plug-in port on the left side of the
printer.
®
BMP 51 Quick Start Guide
2. With the battery label
facing outward, insert the
battery pegs into the peg
slots at the top of the
compartment; then tip the
battery downward into
place.
®
51.
3.
WARNING WARNING WARNING
2. Plug the other end of the cord into an
electrical outlet.
Re-insert the battery door
hinges at the base of the
compartment and swing
the battery compartment
door closed, snapping it
into place.
6/27/11