Unpack The Fireplace (Exclaim-36 Only); Unpack The Fireplace (Exclaim-42 Only) - Heat & Glo Exclaim-36 Installation Manual

D. Unpack the Fireplace (Exclaim-36 only)
• Exclaim-36 is shipped with refractory in place.
• Remove packaging.
• Remove shipping brackets as shown in Figure 3.11.
Replace the screws removed from the fireplace.
• Remove Exclaim-36 from pallet and set aside.
• Skip to F. Frame the Fireplace.
E. Unpack the Fireplace (Exclaim-42 only)
We recommend two installers for hearth stone and refrac-
tory installation!
• Remove back refractory from outside of fireplace by
bending tabs up and lifting refractory out of brackets.
See Figure 3.5.
Figure 3.5 Unpacking Back Refractory
• Bend tabs back down out of the way. See Figure 3.6. Do
not remove screws or brackets from fireplace. If brackets
are removed, fill holes in outer shell with screws.
• Repeat this process to remove side refractories.
Figure 3.6 Bending Refractory Shipping Tabs
Back Down
• Remove smoke shield by removing five screws. See
Figure 3.7. Smoke shield is located at top of fireplace
front.
• Remove screens by removing screw from the end of
each screen rod. See Figure 3.8.
Front Face
Skip
Remove these screws.
Figure 3.7 Removing Smoke Shield
12 Heat & Glo • Exclaim 36/42 • 4013-266 Installers Manual • Rev G • 10/07/13
Smoke Shield
Skip
Figure 3.8 Removing the Screen Rods
• Remove hearth stone by removing three corrugated
shipping spacers (Figure 3.9). Lift hearth stone out of
fireplace. See Figure 3.10.
Figure 3.9 Shipping Spacers
Figure 3.10 Lifting Out the Hearth Stone
• Remove fireplace from pallet.
The fireplace is attached to pallet with two brackets on
each side and rear of outer shell. See Figure 3.11.
• Remove screws from bracket, pallet and fireplace.
Replace screws removed from fireplace.
Figure 3.11 Removing Shipping Brackets