Operation Of Guard Zone [Ata Guard Zone] - JRC JMA-5206 Instruction Manual

3.5.19 Operation of Guard Zone [ATA Guard Zone]

A fan-shaped guard zone can be set to watch for other ships and targets to invade or to automatically
track other invading ships.
The guard zone function can be switched between ON and OFF by placing the cursor on
radar display on page 2-7 and pressing [ENT]. In this case, the guard zone set previously will be ON.
[I] Making Guard Zone (Make Guard Zone 1/2)
Set a fan-shaped operation area of the guard zone.
Procedures 1
2
3
4
Press [ATA MENU] key.
Press [4] key.
Press [1] key.
The ATA Guard Zone Menu will appear.
Select the guide zone where you
want to make an area, pressing the
numeric key [3] to [4].
The Guard Zone selection mode is activated.
GUARD ZONE 1: [3] key
GUARD ZONE 2: [4] key
Using the [EBL] and [VRM] controls,
put the start position of the guard
zone at a desired position, and then
press ENT.
The start position of the guard zone will be
set.
Using the [EBL] and [VRM] controls,
put the end position of the guard
zone at a desired position, and then press ENT.
The end position of the guard zone will be set.
3─59
49
ATA Guard Zone
1. Guard Zone 1
2. Guard Zone 2
3. Make Guard Zone 1
4. Make Guard Zone 2
5. ENT
0. EXIT
or 50 on the
ON
OFF