Troubleshooting - Honeywell HD251(X) Configuration Manual

Troubleshooting

Problem
Nothing appears on the
screen
The image on the
screen is dim
The image on the
screen is dark
The camera is not
working properly and
the surface of the
camera is hot
Motion Detection is not
working
The color of the picture
is not correct
The image on the
screen flickers
The SENS-UP does not
work
Possible Cause
Check the power cable, power supply output and video
connection between the camera and monitor.
• Are the camera lens or the lens glass dirty? Clean the
lens / glass with a soft, clean cloth.
• Adjust the monitor controls, as required.
• If the camera is facing a very strong light source,
change the camera position.
• Adjust the lens focus.
• Adjust the contrast control of the monitor.
• If there is an intermediate device, correctly set the
75 ohms/Hi-z.
Check the camera is correctly connected to an appropriate
regulated power source.
• Has MOTION DET been set to ON in the menu?
• Has an MD AREA been properly defined?
Check the settings in the WHITE BALANCE menu.
Make sure that the camera is not facing direct sunlight or
fluorescent lighting. Change the camera position, if
necessary.
• The AGC setting in the EXPOSURE menu may be set to
OFF.
• Check the EXPOSURE menu and make sure SHUTTER
is set to ----- (not a fixed shutter speed).
Troubleshooting | 31
800-12004V2 - A - 01/2013