Answering system
Answering system settings
NOTES:
If you subscribe to voicemail service through your telephone service provider, see Answering
•
system and voicemail indicators on page 49.
•
If you set the number of rings for the answering system as two or three rings, the caller ID
announce feature may not have enough time to announce the caller's full information.
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/
menu.
2. Press q
or p
CID
press
/SELECT.
MENU
3. Press q
or p
CID
press
/SELECT.
MENU
4. Press q
or p
CID
/SELECT.
press
MENU
5. Use the dialing keys to enter a
backspace and delete a digit.
6. Press
/SELECT to save the setting. You hear a confirmation tone. Press
MENU
CANCEL to cancel.
OFF/
NOTE: If the answering system is off and there is an incoming call, the system answers
after 10 rings and announces, "Please enter your remote access code." For more
information about remote access codes, see pages 56-57.
to scroll to >Answering sys, then
DIR
to scroll to >Ans sys setup, then
DIR
to scroll to >Remote code, then
DIR
two-digit number. Use
SELECT
47
to enter the main
REMOTE CODE
/DELETE to
MUTE
19