Asus MAXIMUS VII GENE User Manual page 127

SATA Mode Selection [AHCI]
This item allows you to set the SATA configuration.
[Disabled] Disables the SATA function.
[IDE] Set to [IDE] when you want to use the Serial ATA hard disk drives as
Parallel ATA physical storage devices.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
(Advanced Host Controller Interface). The AHCI allows the onboard storage
driver to enable advanced Serial ATA features that increases storage
performance on random workloads by allowing the drive to internally
optimize the order of commands.
[RAID] Set to [RAID] when you want to create a RAID configuration from the SATA
hard disk drives.
The following item appears only when you set the SATA Mode Selection to [RAID].
Alternate ID [Disabled]
This item allows you to enable or disable Report alternate ID.
Configuration options: [Disabled] [Enabled]
Aggressive LPM Support [Disabled]
This item is designed for LPM (link power management) support with a better energy saving
conditions. When set to [Enabled], the hot plug function of SATA ports are disabled.
Configuration options: [Disabled] [Enabled]
S.M.A.R.T. Status Check [On]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power-on Self Test) when an error occurs in the
hard disks. Press <Enter> to set this item On or Off.
Configuration options: [On] [Off]
SATA6G_1 (Red) - SATA6G_6 (Red)
Press <Enter> to rename the Intel SATA ports.
SATA6G_1 (Red) - SATA6G_6 (Red) [Enabled]
This item allows you to enable or disable the selected SATA port.
Configuration options: [Disabled] [Enabled]
Hot Plug [Disabled]
These items appears only when the SATA Mode Selection is set to [AHCI] and allows
you to enable or disable SATA Hot Plug Support.
Configuration options: [Disabled] [Enabled]
ASUS MAXIMUS VII GENE
3-41