Asus MAXIMUS VII GENE User Manual page 110

Tweakers' Paradise
The subitems in this menu allow you to set the CPU ratio and features.
BCLK Tuning
Initial BCLK Frequency [Auto]
This item allows you to set input the BCLK Frequency. Use the <+> or <-> key to
adjust the value. The values range from 85.0 to 100.0.
VCCIN Shadow Voltage [Auto]
This item allows you to set a pseudo voltage for VCCIN. Use the <+> or <-> key to
adjust the value. The values range from 0.800V to 2.440V at 0.010V increment.
Termination Anti-Aliasing [Auto]
Set this item to [Enabled] to smooth out the change of the PLL Termination Voltage,
which helps yield a better overclocking result.
Configuration options: [Auto] [Disabled] [Enabled]
Initial PLL Termination Voltage [Auto]
Initial Voltage at which CPU BCLKs are terminated. Maintaining a level close to CPU
Input Voltage helps base clock overclocking. Use the <+> or <-> key to adjust the
value. The values range from 0.00V to 3.00V at 0.00625V increment.
PLL Termination Reset Voltage [Auto]
Set a phase-locked loop termination reset voltage. Use the <+> or <-> key to adjust the
value. The values range from 0.00V to 3.00V at 0.00625V increment.
Eventual PLL Termination Voltage [Auto]
Set an eventual phase-locked loop termination voltage. Use the <+> or <-> key to
adjust the value. The values range from 0.00V to 3.00V at 0.00625V increment.
PCH ICC Voltage [Auto]
Power Supply for the Integrated Clock Controller. Lower may be better.
Clock Crossing VBoot [Auto]
This item allows you to increase the value of the clock crossing voltage boot when
the rising edge of BCLK DN is equal to the falling edge of the BCLK DP. Use the
<+> or <-> key to adjust the value. The values range from 0.1V to 1.9V at 0.00625V
increment.
Clock Crossing Reset Voltage [Auto]
This item allows you to increase the value of the clock crossing reset voltage when
the rising edge of BCLK DN is equal to the falling edge of the BCLK DP. Use the
<+> or <-> key to adjust the value. The values range from 0.1V to 1.9V at 0.00625V
increment.
Configuration options: [Auto] [0.1000] - [1.9000]
Clock Crossing Voltage [Auto]
This item allows you to increase the value of the clock crossing voltage when the rising
edge of BCLK DN is equal to the falling edge of the BCLK DP. Use the <+> or <-> key
to adjust the value. The values range from 0.1V to 1.9V at 0.00625V increment.
3-24
Chapter 3: BIOS setup