Polaroid 100 Series Repair Manual page 52

-
tnldes l/4~' from the bottom of !.he jig
#169441 fFigun: 5-121. RctUlIl the light
(Figure 5-10).
SCJI
if it is in good
condition.
c. Place Ihe camer.t on support block
#CR~
IOCOA and position the jig over the bellows
plate as shown in Figure
5~ll.
Locate the
drill in the bushing and
drill
the housing by
-
rotating the coBar back and forth in your
fingers.
-
-
-
4. Remove the bellows froUl. the body by care­
fully prying the bellows tabs free using tool
SUPPORT BLOCK
FIG.5.11 DRILLING
Replacement
I. Position the light seals over the bellows. If
[he old light seals are damaged. replace lhem.
(The paper side of the rear Ught seal should
be placed against the bellows')
2.
Remove the two labs (from the new bellows)
which would normally hold the bauery ca ble
and position the beHows on the camera body
so the seam is at the bottom.
3. Secure the bellows to the body by carefuUY
bending the tabs back using tool # 169447
(Figure 5-13). Be sure you do not damage
the
bellOWS
or the camera body.
4. Position the tabs on the battery cable over
the proper area of the new bellows and ad­
here them to the bellows using Pliobond.
5. Secure the bellows to the
reu
shutler
housing:
Models 100. 240.250.350'" 360:
Replace the four bellows screws.
-
-
-
-
-
-
-
-
CAREFut.t. Y PRY
UI'
FIG. 5.12 PRYING THE BELLOWS TABS
45