Exit Door Replacement; Slide Block Replacement - Polaroid 100 Series Repair Manual

-
EXIT DOOR REPLACEMENT Replacemenl
RemoVal I, Align the exit door in the framl".'
&1.11<.1
in:o;t:rI
-
the pivot spring llnd pivot slUd!<i.
1.
Open the fear door.
Position tool #169455 against the pivot
-
studs as shown in Figure
S~I).
Squeeze the
tool handle until the pivot studs pop Joose.
). Remove the pivot studs using pliers, Save
rhe Pivot studs and pivot sprrng for reuse.
-
-
-
-
-
""
FIG. 5.2 INSTALLING THE EXIT DOOR
'1
Secure the pivot stllds using tool #169455
(Figure 5·2),
SLIDE BLOCK REPLACEMENT
Removal
I. Open the Te'dr door, remove rhe three slide
block cover retaining screws and swing the
cover out of the way,
,
Slide the shuft out of the edge ,onfrol btlr
and remove the edge control bar and
[WO'
spnngs.
3.
Unhook the spring from the slide block.
allowing the slide block
10
slide free of the
frame roller support. Remove the spring.
Replacement
l. Hook one end of the spring in the notch on
the slide block {FIgure 5-3). Position Ihe
slide block and spring in the frarne roiler
support and hook the spring in the suppoTt
eyehole.
2. Replace the edge control bar (see Figure
5-4). Slide the shaft in the edge control har
-
-
-
-
-
-
-
FIG. 5.3 I
SLIOE
SLOCK.
NOTCH
39